This boat was designed and built by Reets Boatworks in Mayfield, NY. Although it
may look similar to the Italian boat it is significantly different. 

She is powered by twin Ilmor 6.2 V8’s along with a bow and stern thruster to
make dockside maneuvering easy. The integrated swim platform makes for a nice
all-around addition to the boat. 

The boat is cold molded and 3 layers thick with west system epoxy between each
layer. From the waterline down, it has carbon fiber in between each layer and a
layer of Kevlar with fiberglass to protect the outside. That is then coated with
Pettit Protect impervious bottom paint.

This boat has been used sparingly by the owner and has not been used in 2
summers. 

The boat’s design is a replica of the original boat frames and lines while using
modern materials to improve strength, lower maintenance costs, and improve
performance. 

The bottom is 3 layers of ¼” Okoume plywood epoxy coated on all sides, bi-axial
carbon fiber in-between the 1st, 2nd and 3rd layers. The bottom is wrapped with
6oz fiberglass and then faired using West system 410 microfibers. 

The sides and the deck are composed of 3 layers. Two inner ¼” plywood skins will
be coated on all surfaces and then planked with 3/8” Mahogany. The sides and
deck were then stained traditional colors and varnished with 12-14 coats of
Pettit flagship varnish.

All the screws and bolts used in the boat are stainless steel. All the epoxy
used is the West System. 

The bilge area is Coated with West system epoxy and then varnished with two
coats. 

35 Yachts is pleased to assist you in the purchase of this vessel. This boat is
centrally listed by Denison Yachting. It is offered as a convenience by this
broker/dealer to its clients and is not intended to convey direct representation
of a particular vessel